Hat Size Chart

WHAT IS MY HAT SIZE?

Once you've chosen your favorite Rock'em hats, you'll need to know your hat size is! Your hat should be reasonably snug so that a light wind won't blow it off your head, but not so tight to the point where it will cause discomfort or a headache. Here it what our Rock'em hat experts recommend.

 

THE MEASURING TAPE METHOD

Start with a measuring tape (or a piece of string you can measure later), and wrap it around your head, placing it where your hat will sit- typically, at the middle of your forehead and about 1/8" above your ear. Hold the tape firmly, but not uncomfortably tight. Find your size using the chart below. If your measurement falls between sizes, order a size up; you can always add a bit of padding in the sweatband to achieve the perfect fit.
Sizing, Fit & Care – Brixton

 

HOW TO MEASURE YOUR HAT SIZE:

Traditional Style
  1. Use a textile measuring tape (or string) to measure the distance around your head crossing through the center part of the back of your head + the forehead just above the eyebrow. The tape should be level with the ground.
  2. Check the measurement of the tape wrapped around your head. Hat sizing is in cm. If you are in-between sizes, we suggest sizing up + adjusting your hat accordingly.

 

The Halo Style

 

  1. Use a textile measuring tape to measure the distance around your head passing through the back of your head, just above the neck, + the front of your head high on the brow. The tape should be higher in front than in back.
  2. Check the measurement of the tape wrapped around your head. Wearing a hat Halo style is usually a smaller hat size than wearing a hat traditionally. Since there is typically a difference in measurement we recommend using the larger of the two hat sizes. If you are in-between sizes, we suggest sizing up and adjusting down.

 

Additional Suggestions:

Hat Sizing tape an additional option for tightening the fit of your hat. If your hat fits lose you may request we send you hat tape (refill) at NO COST, just pay to ship!

 

Place the foam tape on the inside of your hat, behind the sweatband, with the sticky side facing towards the hat wall. Wrap the tape completely around the hat for maximum size decrease or cut tape length in half for a more moderate decrease. Size to fit prior to removing the adhesive cover. Once the fit is correct, remove the adhesive cover, press firmly into place, and you are ready to wear your new Rock'em Hat!!